Stack Pack Media is a Dr. Dabber affiliate partner. If you buy through my link, I may earn a commission.
Get every story first: join The Pack Report
We already broke down how to roll a paper. Now we're switching lanes. A lot of people get a portable e-rig and never get a straight answer on the basics: how much goes in, where it goes, and how to keep the thing running right. So here it is, The Pack Report way: step by step, and every step pulled straight from Dr. Dabber's own Ghost² knowledge base. No guesswork, no "my cousin said."
Step 1: Power Up and Set Your Heat
- Hold the button for 2 seconds to turn it on.
- Click once to see your current temperature setting. Click again within 3 seconds to change it.
- Click 3 times to switch the heating mode. Descent is the default.
Step 2: Load It Right
- Flip the top open to reveal the heating chamber.
- Use the dab tool from the kit to place your concentrate directly on the bottom of the eChamber. Dr. Dabber says that's where you get the best results.
- Go small. Dr. Dabber recommends about half a pea size at a time. Overloading restricts airflow and actually produces less clouds.
- Close the top.
Step 3: Start the Heat Cycle
- Click the button 2 times to start a heating cycle.
- The light pulses red while it heats. When it turns green and vibrates, it's ready.
- The cycle runs 30 seconds once it hits your set temp. Double-click during heating to add 15 seconds (once per cycle), or click once to cancel.
Step 4: Keep It Clean
- Don't dry burn the eChamber. There should always be a small amount of oil in it while in use.
- Clean with isopropyl alcohol (ISO). Pull the mouthpiece, silicone top and airflow regulator, and soak them in ISO for no more than 20 minutes.
- Swab the eChamber. Heat it 3 to 5 seconds, soak up residue with a dry cotton swab, then hit stubborn spots with an ISO-dipped swab. Dry heat 3 to 5 more seconds to clear leftover ISO.
- Air dry everything for 20+ minutes, then reassemble.
- Never soak the eChamber in ISO or any liquid, and only use a paper towel with warm water on the shell. ISO can fade the finish.
Comments
Post a Comment