Heads up: this post has my Dr. Dabber affiliate link, and I may earn a commission if you shop through it.
Back in 2013, the Ghost was the device that launched Dr. Dabber. Now the Ghost² is here, and Dr. Dabber calls it a reimagining of that original: refined, re-engineered and reborn for the modern era. We already ran the spec sheet. This one is different. This is the cheat sheet, the stuff you want in your pocket once the Ghost² is in your hand.
The whole thing runs off one button. Dr. Dabber's pitch is simple: a couple of taps to set it up the way you like, then you can forget the combos. Here's how the taps break down, straight from Dr. Dabber's own knowledge base.
The Button Combos
- Hold 2 seconds: power on or off.
- Click once: shows your current temperature setting. Click again within 3 seconds to change it.
- Click twice: starts a heating cycle. The light pulses red while it heats, then turns green and vibrates when it's ready.
- Click three times: switches the dynamic heating mode.
- Click four times (while on): battery check. Green means 70% or higher, yellow means 30 to 70%, red means 30% or lower.
A heating cycle runs 30 seconds once it hits your set temp. Double-click during heating to add 15 seconds (once per cycle), or single-click to cancel. And the Ghost² remembers your last temperature and mode, so you're not resetting every time you power it on.
Read the Colors
Five temperature settings, each with its own color (approximate, per Dr. Dabber):
- Purple: 420°F
- Blue: 450°F
- Cyan: 480°F
- Yellow: 510°F
- White: 540°F
Dr. Dabber's own guidance: lower settings for maximizing flavor, higher settings for maximizing cloud production.
The light also tells you the heating mode. A downward pattern is Descent, the default, where the temperature slowly drops after hitting your setting, like a banger cooling off. A pulse is Steady, holding one temperature through the whole cycle. An upward pattern is Ascent, where the temperature slowly climbs.
Keep It Running Right
The Ghost² heats from the sidewalls with what Dr. Dabber calls radial heating, and it charges over USB-C in about an hour, good for roughly 20 heating cycles. Pass-through charging means you can use it while it charges. When the light blinks white three times, it's time to plug in. It also shuts itself off after 15 minutes of no use, which helps the battery and stops accidental presses in a bag or pocket.
Dr. Dabber built in protection against over-voltage, over-current, under-voltage, over-temperature, short-circuit and reverse-polarity across the unit, charger and battery, and backs the battery, charger and electrical components with a 1-year warranty.
The eChamber is the part that wears. Dr. Dabber says to plan on replacing it every 3 to 12 months depending on use and cleaning, and to recalibrate the unit every time you install a new one. Their knowledge base walks through the cleaning and recalibration steps, so read the manual before you run it.
Want more conversations on culture, business and the come-up? Tap in with The Network Podcast.
For adults 21+ only. Keep cannabis away from children and pets.
Comments
Post a Comment